# UDP Station Status

**URL:** <https://community.tempest.earth/t/udp-station-status/6789>\
**Category:** Developers\
**Tags:** udp\
**Created:** [June 9, 2020, 4:25pm UTC](https://community.tempest.earth/t/udp-station-status/6789 "2020-06-09T16:25:34Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![ian2](https://sea2.discourse-cdn.com/flex020/user_avatar/community.tempest.earth/ian2/32/8106_2.png) [@ian2](https://community.tempest.earth/u/ian2)\
**Post date:** [June 9, 2020, 4:25pm UTC](https://community.tempest.earth/t/udp-station-status/6789/1 "2020-06-09T16:25:34Z")

</div>

I’ve noticed that the station status shows two rssi fields:

{  
“serial\_number”: “AR-00004049”,  
“type”: “device\_status”,  
“hub\_sn”: “HB-00000001”,  
“timestamp”: 1510855923,  
“uptime”: 2189,  
“voltage”: 3.50,  
“firmware\_revision”: 17,  
**"rssi": -17,**  
\*\* “hub\_rssi”: -87\*\*  
“sensor\_status”: 0,  
“debug”: 0  
}

Could someone clarify what those refer to specifically? Is it the RSSI of the wifi signal as seen from the hub, the RF signal of the station as seen from the hub, the hub’s RF signal as seen from the station? It’s not clear what these are specifically. I assume the units are in dBm?

---

<div class="post-metadata">

**Author:** ![peter](https://sea2.discourse-cdn.com/flex020/user_avatar/community.tempest.earth/peter/32/1365_2.png) [@peter](https://community.tempest.earth/u/peter)\
**Post date:** [June 9, 2020, 5:30pm UTC](https://community.tempest.earth/t/udp-station-status/6789/2 "2020-06-09T17:30:03Z")

</div>

I think you’ll find the answer in this thread:

[https://community.tempest.earth/t/air-hub-rssi-reports-zero-edited-was-sky/2037/6?u=peter](https://community.tempest.earth/t/air-hub-rssi-reports-zero-edited-was-sky/2037/6)