My sky unit broke down. Before throwing it in the recycling bin, I want to open it up. Four screws at the bottom was step 1, desoldering the power wires step 2, I didn’t want to open up the antenna in order to desolder it, so I cut the wire. Now I’m left with the top part. There was a tiny bit of g…

ok so a thin screwdriver prize it in between to open a small gap then move it up , unless they superglued later revisions , i recall all came off without any heavy force , tempted to dig one out of the cupboard and video it for you … just keep trying …

is there some glue only next to the transducers, or all around the edge?

all of my six :grin: had some thin silicon seal more like a white elastic band. dont recall anything around then wind sensors it was a couple of years ago .but its not the wind sensors keeping the lid on . your see when you pop it off…

easier said than done. I went around with a knife a dozen times, still no movement. I’ve put the white part around the metal in a vise and pulled the cap. No movement. I even put the metal part in the vise but I assume that is attached to the plastic part around the brightness sensor, so I didn’t ex…

got it. scewdriver and more brute force did the trick. There are four tiny notches next to each transducer. Some weather influence is visible around there. Inside, where the electronics are, everything still looks unweathered.

cool now you can salvage the piezoelectric and use it for an acoustic guitar pickup as i did :grin: have fun…

wow, turning a weather station into a guitar, that’s cool. Actually the only thing working in this unit was the battery sensor and the piezoelectric.

just for completeness, here is the disassembled unit (minus the cover) [sky-disassembled]

I am late to reply now that you managed it, but this post shows my method and the tabs: https://community.tempest.earth/t/failing-sky-investigation-discussion/7034/4 cheers Ian :slight_smile:

that would have been helpful. In my case the nut showed some corrosion. Using different metals for nut and bold isn’t generally a good idea, as this accelerates the corrosion. I have no idea why the wind and solar sensors failed, but battery and rain were working fine.

@sunny and @iladyman , once you have taken the four screws out the bottom, how do you get the outer ‘sleeve’ to separate from the main body of the Sky? I’ve pushed and pulled all over, but I can’t get anything to budge.

Opening up a broken sky unit

Tempest Owners

Topic		Replies	Views
Sky - help in tear down required General sky	4	188	September 24, 2025
Bottom cap on Tempest EXTREMELY hard to remove Tempest Owners tempest	2	568	August 3, 2020
How to repair a fallen Tempest Tempest Owners	0	1263	January 26, 2021
Looking for broken Tempest weather station General	31	2917	March 11, 2026
Tempest dome water resistance Tempest Owners tempest	6	440	October 25, 2021

Opening up a broken sky unit

Related topics